News

The value of the optical power will have the most obvious effect on the signal during transmission, and this optical power is also the easiest to test, and this value can be tested by the optical power.   Optical power - Use an optical power meter to test whether th...

In the use of optical modules, it is inevitable to encounter a variety of problems. To reduce the fault phenomenon and ensure the stability of the optical module. There are different detection functions for optical modules.   The 1X9 module mainly detects the signal...

The Output Power refers to the average output optical power of the light source at the sending end of the optical module, also known as the output optical power, which can be understood as the intensity of light. Formula: P(dBm)=10Log(P/1mW) The unit is W or mW or dBm. (Where W or mW is a linear ...

It refers to the interface that connects an optical module to an optical fiber jumper. It can be connected through a single-mode or multi-mode optical fiber. The following is an analysis based on different interfaces. At present, there are mainly optical interfaces on the market: MPO, LC, SC, FC,...

The reason why optical fiber replaces the long-distance transmission of the network cable is that optical fiber transmission has low loss, and its loss is mainly divided into the following: Loss is the loss of light energy caused by the absorption and scattering of the medium (air) and leakage (t...

The current lasers are: FBG, FB, DFB, etc., among which the most commonly used are FP and DFB two lasers FBG :Fiber Bragg Grating. FP: Fabry-Perot, Fabry-Perot laser diode DFB: Distributed Feedback Laser. For the mainstream commonly used FB, DFB. DFB’s laser is based on the FP laser using...