Blog

The Output Power refers to the average output optical power of the light source at the sending end of the optical module, also known as the output optical power, which can be understood as the intensity of light. Formula: P(dBm)=10Log(P/1mW) The unit is W or mW or dBm. (Where W or mW is a linear ...

It refers to the interface that connects an optical module to an optical fiber jumper. It can be connected through a single-mode or multi-mode optical fiber. The following is an analysis based on different interfaces. At present, there are mainly optical interfaces on the market: MPO, LC, SC, FC,...

The reason why optical fiber replaces the long-distance transmission of the network cable is that optical fiber transmission has low loss, and its loss is mainly divided into the following: Loss is the loss of light energy caused by the absorption and scattering of the medium (air) and leakage (t...

The current lasers are: FBG, FB, DFB, etc., among which the most commonly used are FP and DFB two lasers FBG :Fiber Bragg Grating. FP: Fabry-Perot, Fabry-Perot laser diode DFB: Distributed Feedback Laser. For the mainstream commonly used FB, DFB. DFB’s laser is based on the FP laser using...

(1) Central wavelength The operating wavelength of the optical module is actually a range, but there is a more obvious difference between single mode and multi-mode. Then expressed, generally named according to the most central wavelength. The central wavelength is measu...

According to the different categories of development time: Optical modules are classified into PON optical modules and traditional optical modules When using traditional optical modules: The optical signal transmission mode is point-to-point (P2P: that is, one to one), a...