● Inopindirana neSFP Multi-Source Agreement (MSA) SFF-8074i
● Inopindirana neITUT-T G.984.2, G.984.2 Amendment 1
● Inopindirana neITUT G.988 ONU management uye control interface (OMCI) tsanangudzo
● Inopindirana neSFF 8472 V9.5
● Inoenderana neFCC 47 CFR Chikamu 15, Kirasi B
● Inoenderana neFDA 21 CFR 1040.10 uye 1040.11
Iyo HTR6001X yakatevedzana transceiver ndeye yakakwira performance module kune imwechete fiber
kutaurirana uchishandisa 1310nm burst-mode transmitter uye 1490nm inoenderera-modhi.
receiver.Inoshandiswa mune optical network terminal (ONT) yeGPON ONU Kirasi B+ maapplication
naMac mukati.
Iyo Transmitter yakagadzirirwa imwe chete modhi fiber uye inoshanda pane inomina wavelength
ye1310nm.Iyo transmitter module inoshandisa DFB laser diode ine yakazara IEC825 uye CDRH kirasi 1.
kuchengetedzwa kweziso.
Iyo inogamuchira chikamu inoshandisa hermetic yakarongedzwa APD-TIA (APD ine trans-impedance amplifier) uye
a limiting amplifier.Iyo APD inoshandura optical power kuita magetsi emagetsi uye ikozvino iri
V1.0 peji 2 ye10
yakashandurwa kuita voltage neiyo trans-impedance amplifier.Iyo yakasiyana DATA uye / DATA CML data
masaini anogadzirwa neinodzikamisa amplifier.
Iyo yakagadziridzwa Digital Diagnostic Monitoring Interface yakaiswa mukati
transceivers.Inobvumira nguva chaiyo yekuwana kune iyo transceiver inoshanda paramita senge transceiver
tembiricha, laser bias ikozvino, burst mode transmitted optical simba, yakagamuchira optical simba uye
transceiver supply voltage nekuverenga yakavakirwa-mukati ndangariro neI2C interface.
●Gigabit-inokwanisa Passive Optical Networks (GPON)
● HTR6001X iSFP inoenderana neMSA isingabatanidzi maoptics eONU chete, asi ese
zvemagetsi zvinodawo.Iyo "PON paChimuti" iyo yese FTTH ONU mune zvishoma
yakakura SFP.Inogona kubatirwa mumidziyo yetiweki.Kubvumira iyo data interfaces pane a
chinja, router, PBX, nezvimwe kuti zvigadziriswe kune dzakasiyana siyana fiber nharaunda uye chinhambwe
zvinodiwa
● HTR6001X yakagadzirwa se-dual-mode ONU stick, inotsigirawo EPON ONU OAM.It
inogona kuiswa paEPON system uye paGPON system .Ichazvigadzira
chinongedzo cheEPON neEPON OLT kana GPON link neGPON OLT.
| Parameter | Symbol | Minimum | Maxim | Unit | Cherechedza |
| Storage Ambient Temperature | TSTG | -40 | 85 | °C | |
| Operating Case Temperature | Tc | 0 | 70 | °C | C-Temp |
| -40 | 85 | °C | I-Temp | ||
| Kushanda Humidity | OH | 5 | 95 | % | |
| Power Supply Voltage | VCC | 0 | 3.63 | V | |
| Receiver Yakakuvadzwa Threshold | +4 | dBm | |||
| Soldering Temperature | 260/10 | °C/S |
| Parameter | Symbol | Minimum | Typical | Maxim | Unit | Cherechedza |
| Power Supply Voltage | VCC | 3.13 | 3.3 | 3.47 | V | 3.3V±5% |
| Kuparadza Simba | PD | 2.00 | 2.48 | W | ||
| Operating Case Temperature | Tc | 0 | 70 | °C | C-Temp | |
| -40 | 85 | °C | I-Temp | |||
| Kushanda Humidity Range | OH | 5 | 85 | % | ||
| Data Rate kumusoro | 1.244 | Gbit/s | ||||
| Data Rate kuzasi | 2.488 | Gbit/s | ||||
| Data Rate Drift | -100 | +100 | PPM |
| Parameter | Symbo | Minimu | Typical | Maxim | Unit | Cherechedza |
| Optical Center Wavelength | λC | 1290 | 1330 | nm | ||
| Side Mode Suppression Ratio | SMSR | 30 | dB | |||
| Optical Spectrum Width | ∆λ | 1 | nm | |||
| Avhareji Launch Optical Power | Po | +0.5 | +5 | dBm | 1 | |
| Simba-OFF Transmitter Optical | Poff | -45 | dBm | |||
| Extinction Ratio | ER | 9 | dB | 2 | ||
| Nguva Yokusimuka/Kudonha (20% -80%) | TR/TF | 260 | ps | 2,3 | ||
| Batidza Nguva paBurst mode | Ton | 12.8 | ns | |||
| Dzima Nguva paBurst mode | Toff | 12.8 | ns | |||
| RIN15OMA | -115 | dB/Hz | ||||
| Optical Return Loss Tolerance | 15 | dB | ||||
| Transmitter Reflectance | -6 | dB | ||||
| Transmitter uye Dispersion Chirango | TDP | 2 | dB | 4 | ||
| Optical Waveform Dhizaini | Inopindirana neITU-T G.984.2 | 5 | ||||
| Data Input Differential Swing | 300 | 1600 | mV | 6 | ||
| Input Differential Impedance | 90 | 100 | 110 | Ω | ||
| Tx-Disable Voltage (Enable) | 0 | 0.8 | V | |||
| Tx-Disable Voltage (Disable) | 2.0 | VCC | V | |||
| Tx-Fault Output (Zvose) | 0 | 0.8 | V | |||
| Tx-Fault Output (Fault) | 2.0 | VCC | V | |||
Cherechedza 1: Yakatangwa mu9/125um Single Mode Fiber.
Cherechedzo chechipiri: kuyerwa nePRBS 223-1 bvunzo patani @1.244Gbit/s.Cherechedza 3: Kuyerwa neBessel-Thompson sefa OFF.
Cherechedzo 4: Yakakura yekunzwa chirango nekuda kwekutumira uye kuparadzira maitiro kuburikidza ne20km yeSMF optical fiber.Cherechedza 5: Transmitter eye mask tsanangudzo (Mufananidzo 1).
Cherechedza 6: Inoenderana neLVPECL yekupinda, DC yakabatanidzwa mukati.
Mufananidzo 1 Transmitter Ziso Mask Definiti
Mufananidzo 1 Transmitter Ziso Mask Tsanangudzo
| Parameter | Symbol | Minimu | Typical | Maxim | Unit | Notes |
| Kushanda Wavelength | 1480 | 1490 | 1500 | nm | ||
| Sensitivity | SEN | -28 | dBm | |||
| Saturation Optical Power | SAT | -8 | dBm | 1 | ||
| LOS Dessert Level | -29 | dBm | ||||
| LOS Assert Level | -40 | dBm | 2 | |||
| LOS Hysteresis | 0.5 | 5 | dB | |||
| Receiver Reflectance | -20 | dB | ||||
| 38 | dB | 1550nm | ||||
| WDM Filter Isolation | 35 | dB | 1650nm | |||
| Data Output Differential Swing | 300 | 1200 | mV | 3 | ||
| LOS low voltage | 0 | 0.8 | V | |||
| LOS yakakwira voltage | 2 | VCC | V |
Cherechedzo 1: kuyerwa nePRBS 223-1 test pattern @2.488Gbit/s uye ER=9dB, BER =10-12.
Cherechedza 2: Kuderera kwemagetsi emagetsi pamusoro pezinga rakatarwa kuchaita kuti Los output ichinje kubva kune yakaderera kusvika kune yakakwirira;
Kuwedzera kwemagetsi emagetsi pasi pezinga rakatarwa kuchaita kuti Los kubuda kwekuchinja kubva kune yakakwirira kuenda kune yakaderera.
Cherechedzo 3: CML inobuda, AC yakabatanidzwa mukati, yakavimbiswa muhuwandu hwakazara hwekuisa optical simba (-8dBm kusvika -28dBm).
Mufananidzo 2 EEPROM Information
Mufananidzo 3 Package Outline (chikamu: mm)
| PIN | Zita | Tsanangudzo | Notes |
| 1 | VeeT | Transmitter Ground | 1 |
| 2 | Tx-Fault | Transmitter Mhosva Chiratidzo, Zvakajairwa "0", kukanganisa:Logic "1" kubuda, LVTTL | 2 |
| 3 | Tx-Disable | Transmitter Disable;inodzima transmitter laser | 3 |
| 4 | Mod-Def(2) | SDA I2C Data line | 2 |
| 5 | Mod-Def(1) | SCL I2C Clock mutsara | 2 |
| 6 | Mod-Def(0) | Module Kusipo, yakabatana neVeeR | 2 |
| 7 | Rate Sarudza | Kune Dying Gasp detect, isa yakaderera inoshanda | |
| 8 | LOS | Kurasika Kwechiratidzo | 2 |
| 9 | VeeR | Receiver Ground | 1 |
| 10 | VeeR | Receiver Ground | 1 |
| PIN | Zita | Tsanangudzo | Notes |
| 11 | VeeR | Receiver Ground | 1 |
| 12 | RD- | Inv.Received Data Output | |
| 13 | RD+ | Received Data Output | |
| 14 | VeeR | Receiver Ground | 1 |
| 15 | VccR | Receiver Simba | 1 |
| 16 | VccT | Transmitter Power | |
| 17 | VeeT | Transmitter Ground | 1 |
| 18 | TD+ | Transmit Data In | |
| 19 | TD- | Inv.Transmit Data In | |
| 20 | VeeT | Transmitter Ground | 1 |
Notes:
1. Module redunhu pasi rakaparadzaniswa kubva module chassis pasi mukati memodule.
2. Mapini achadhonzwa ne 4.7K-10KΩ kune voltage pakati pe 3.13V uye 3.47V pane host board.
3. Pini inodhonzwa kusvika kuVccT ine 4.7K-10KΩ resistor mune module.
Mufananidzo 4 Pin Out Kudhirowa (Kumusoro maonero)
Mufananidzo 5 Recommended Board Layout Hole Muenzaniso uye Panel Mounting
Zvigadzirwa zvikamu
Nyora meseji yako pano uye titumire kwatiri