● E lumellana le Tumellano ea Mehloli e Meholo ea SFP (MSA) SFF-8074i
● E lumellana le ITUT-T G.984.2, G.984.2 Sehlomathiso 1
● E lumellana le litlhaloso tsa ITUT G.988 ONU tsa tsamaiso le sebopeho sa taolo (OMCI).
● E lumellana le SFF 8472 V9.5
● E lumellana le FCC 47 CFR Karolo ea 15, Sehlopha sa B
● E lumellana le FDA 21 CFR 1040.10 le 1040.11
HTR6001X letoto la transceiver ke mojule oa ts'ebetso e phahameng bakeng sa fiber e le 'ngoe
Lipuisano tse sebelisang 1310nm burst mode transmitter le 1490nm continuous-mode
moamoheli.E sebelisoa ho terminal ea marang-rang ea optical (ONT) bakeng sa lits'ebetso tsa GPON ONU Class B+
le Mac ka hare.
Transmitter e etselitsoe fiber ea mofuta o le mong 'me e sebetsa ka bolelele ba maqhubu
boholo ba 1310nm.Mojule oa transmitter o sebelisa DFB laser diode e nang le IEC825 e felletseng le CDRH sehlopha sa 1.
polokeho ya mahlo.
Karolo ea moamoheli e sebelisa hermetic packaged APD-TIA (APD e nang le amplifier ea trans-impedance) le
amplifier e fokolang.APD e fetola matla a optical ho ba motlakase 'me hona joale ke
V1.0 leqepheng la 2 ho tse 10
e fetoletsoeng ho voltage ke trans-impedance amplifier.Lintlha tse fapaneng tsa DATA le / DATA CML
matšoao a hlahisoa ke amplifier e fokolang.
Sesebelisoa se ntlafalitsoeng sa Digital Diagnostic Monitoring Interface se kenyellelitsoe ho
li-transceivers.E lumella ho fihlella nako ea sebele ho li-parameter tse sebetsang tsa transceiver tse kang transceiver
mocheso, laser bias current, burst mode transmitted optical power, amohetse matla a optical le
motlakase oa phepelo ea transceiver ka ho bala mohopolo o hahelletsoeng ka har'a sebopeho sa I2C.
●Gigabit-caable Passive Optical Networks (GPON)
● HTR6001X ke SFP e ikamahanyang le MSA e kopanyelletsang optics bakeng sa ONU feela, empa kaofela
le lisebelisoa tsa elektroniki.Ke "PON holim'a Thupa" eo FTTH ONU kaofela hanyenyane
SFP e phahameng haholo.E ka hokeloa lisebelisoa tsa marang-rang.Ho lumella likhokahano tsa data ho a
switjha, router, PBX, joalo-joalo ho etsoa bakeng sa maemo a fapaneng a fiber le sebaka
ditlhoko
● HTR6001X e entsoe e le thupa ea ONU ea mefuta e 'meli, hape e tšehetsa EPON ONU OAM.Eona
e ka sebelisoa ka bobeli ho sistimi ea EPON le ho sistimi ea GPON .E tla theha ka bo eona
sehokelo sa EPON le sehokelo sa EPON OLT kapa GPON le GPON OLT.
| Paramethara | Letšoao | Bonyane | Maxim | Yuniti | Hlokomela |
| Storage Ambient Mocheso | TSTG | -40 | 85 | °C | |
| Mocheso oa Mocheso oa Ts'ebetso | Tc | 0 | 70 | °C | C-Temp |
| -40 | 85 | °C | Ke -Temp | ||
| Mongobo o sebetsang | OH | 5 | 95 | % | |
| Matla a Phepelo ea Matla | VCC | 0 | 3.63 | V | |
| Moamoheli o Senyehileng Moepa | +4 | dBm | |||
| Mocheso oa Soldering | 260/10 | °C/S |
| Paramethara | Letšoao | Bonyane | E tloaelehileng | Maxim | Yuniti | Hlokomela |
| Matla a Phepelo ea Matla | VCC | 3.13 | 3.3 | 3.47 | V | 3.3V±5% |
| Ho felloa ke Matla | PD | 2.00 | 2.48 | W | ||
| Mocheso oa Mocheso oa Ts'ebetso | Tc | 0 | 70 | °C | C-Temp | |
| -40 | 85 | °C | Ke -Temp | |||
| Ts'ebetso ea Mongobo oa Mongobo | OH | 5 | 85 | % | ||
| Data Rate holimo | 1.244 | Gbit/s | ||||
| Data Rate tlase molapong | 2.488 | Gbit/s | ||||
| Data Rate Drift | -100 | +100 | PPM |
| Paramethara | Letšoao | Bonyane | E tloaelehileng | Maxim | Yuniti | Hlokomela |
| Setsi sa Optical Wavelength | λC | 1290 | 1330 | nm | ||
| Side Mode Suppression Ratio | SMSR | 30 | dB | |||
| Optical Spectrum Width | ∆λ | 1 | nm | |||
| Karolelano ea Launch Optical Power | Po | +0,5 | +5 | dBm | 1 | |
| Motlakase oa ho tima Transmitter Optical | Poff | -45 | dBm | |||
| Karolelano ea Phello | ER | 9 | dB | 2 | ||
| Nako ea ho Tsoha/Hoetla (20%-80%) | TR/TF | 260 | ps | 2,3 | ||
| Bulela Nako ka mokhoa oa Burst | Ton | 12.8 | ns | |||
| Tima Nako ka mokhoa oa Burst | Toff | 12.8 | ns | |||
| RIN15OMA | -115 | dB/Hz | ||||
| Mamello ea Tahlehelo ea Optical Return | 15 | dB | ||||
| Phetiso ea Transmitter | -6 | dB | ||||
| Kotlo ea Phetiso le Phatlalatso | TDP | 2 | dB | 4 | ||
| Setšoantšo sa Optical Waveform | E lumellana le ITU-T G.984.2 | 5 | ||||
| Data Input Differential Swing | 300 | 1600 | mV | 6 | ||
| Kena Phapano ea Impedans | 90 | 100 | 110 | Ω | ||
| Tx-Disable Voltage (Enable) | 0 | 0.8 | V | |||
| Tx-Disable Voltage (Ho tima) | 2.0 | VCC | V | |||
| Tx-Fault Output (Tlwaelehileng) | 0 | 0.8 | V | |||
| Tx-Fault Output (Fault) | 2.0 | VCC | V | |||
Tlhokomeliso ea 1: E tsebisitsoe ho 9/125um Single Mode Fiber.
Tlhokomeliso ea 2: E lekantsoe ka PRBS 223-1 mokhoa oa teko @1.244Gbit/s.Tlhokomeliso ea 3: E lekantsoe ka mochini oa Bessel-Thompson OFF.
Tlhokomeliso ea 4: Kotlo e kholo ea kutlo ka lebaka la phetisetso le phello ea ho hasana ka 20km ea SMF optical fiber.Tlhokomeliso ea 5: Litlhaloso tsa mask a mahlo a Transmitter (Setšoantšo sa 1).
Tlhokomeliso ea 6: E lumellana le tlhahiso ea LVPECL, DC e kopantsoe ka hare.
Setšoantšo 1 Phetiso Leihlo Mask Definiti
Setšoantšo 1 Phetiso Leihlo Mask Litlhaloso
| Paramethara | Letšoao | Bonyane | E tloaelehileng | Maxim | Yuniti | Lintlha |
| Wavelength e sebetsang | 1480 | 1490 | 1500 | nm | ||
| Kutloisiso | SEN | -28 | dBm | |||
| Saturation Optical Matla | SAT | -8 | dBm | 1 | ||
| Boemo ba Dessert ea LOS | -29 | dBm | ||||
| Boemo ba Bopaki ba LOS | -40 | dBm | 2 | |||
| LOS Hysteresis | 0.5 | 5 | dB | |||
| Reflectance ea moamoheli | -20 | dB | ||||
| 38 | dB | 1550nm | ||||
| Ho itšehla thajana ha Sefa sa WDM | 35 | dB | 1650nm | |||
| Phapang ea Phapang ea Tlhahiso ea data | 300 | 1200 | mV | 3 | ||
| LOS motlakase o tlase | 0 | 0.8 | V | |||
| LOS matla a phahameng | 2 | VCC | V |
Tlhokomeliso ea 1: E lekantsoe ka PRBS 223-1 mokhoa oa teko @2.488Gbit / s le ER = 9dB, BER =10-12.
Tlhokomeliso ea 2: Ho fokotseha ha matla a optical ka holim'a boemo bo boletsoeng ho tla etsa hore tlhahiso ea Los e fetohe ho tloha boemong bo tlaase ho ea boemong bo phahameng;
Ho eketseha ha matla a optical ka tlase ho tekanyo e boletsoeng ho tla etsa hore tlhahiso ea Los e fetohe ho tloha boemong bo phahameng ho ea boemong bo tlaase.
Tlhokomeliso ea 3: Tlhahiso ea CML, AC e kopantsoe ka hare, e tiisitsoe ka mefuta e mengata ea matla a ho kenya (-8dBm ho -28dBm).
Setšoantšo 2 EEPROM Boitsebiso
Setšoantšo 3 Sephutheloana Kemiso (yuniti: mm)
| PIN | Lebitso | Tlhaloso | Lintlha |
| 1 | VeeT | Sebaka sa Transmitter | 1 |
| 2 | Tx-Fault | Letšoao la Phoso ea Transmitter, Tloaelehileng "0", phoso:Logic "1" sephetho, LVTTL | 2 |
| 3 | Tx-Disable | Ho Koala ka Transmitter;e tima laser transmitter | 3 |
| 4 | Mod-Def(2) | Lethathamo la lintlha tsa SDA I2C | 2 |
| 5 | Mod-Def(1) | SCL I2C Clock line | 2 |
| 6 | Mod-Def(0) | Mojule ha e eo, e hokahaneng le VeeR | 2 |
| 7 | Rate Khetha | Bakeng sa ho lemoha ha Dying Gasp, kenya tšebetsong e tlase | |
| 8 | TLHOKOMELO | Tahlehelo ya Letshwao | 2 |
| 9 | VeeR | Sebaka sa Moamoheli | 1 |
| 10 | VeeR | Sebaka sa Moamoheli | 1 |
| PIN | Lebitso | Tlhaloso | Lintlha |
| 11 | VeeR | Sebaka sa Moamoheli | 1 |
| 12 | RD- | Inv.Sephetho se Amohetseng Data | |
| 13 | RD+ | Sephetho se Amohetseng Data | |
| 14 | VeeR | Sebaka sa Moamoheli | 1 |
| 15 | VccR | Matla a ho amohela | 1 |
| 16 | VccT | Matla a ho fetisa | |
| 17 | VeeT | Sebaka sa Transmitter | 1 |
| 18 | TD+ | Fetisetsa Boitsebiso | |
| 19 | TD- | Inv.Transmit Data In | |
| 20 | VeeT | Sebaka sa Transmitter | 1 |
Lintlha:
1. Sebaka sa potoloho sa mojule se arohane le sebaka sa chassis sa module ka har'a mojulu.
2. Lithakhisa li tla huloa ka 4.7K-10KΩ ho motlakase pakeng tsa 3.13V le 3.47V ho board board.
3. Pini e huloa ho fihlela VccT ka 4.7K-10KΩ resistor mojulung.
Setšoantšo 4 Pin Out Ho taka (Holimo sheba)
Setšoantšo 5 E khothalelitsoe Boto Sebopeho Sekoti Mohlala le Phanele Ho phahamisa
Lihlopha tsa lihlahisoa
Ngola molaetsa wa hao mona mme o re romele wona