HARDWARE SPECIFICATION
| Item | Parameter |
| PON Interface | 1 GPON BoB(Bosa on Board) Receiving sensitivity:≤-27dBm Transmitting optical power:0~+5dBmTransmission distance: 20KM |
| Wavelength TX:1310nm,RX:1490nm | |
| Optical Interface SC/APC Connector | |
| Chip Spec RTL9607C DDR3256MB | |
| Flash 1Gbit SPI NAND Flash | |
| 2×10/100/1000Mbps auto adaptive Ethernet interfaces. | |
| LAN Interface | Full/Half, RJ45 connector |
| Compliant with IEEE802.11b/g/n,ac 2.4G Operating frequency:2.400-2.4835GHz 5.8G Operating frequency:5.150-5.825GHz Wireless 2.4G 2*2 MIMO, rate up to 300Mbps 5.8G 2*2 MIMO, rate up to 867Mbps4 external antennas 5dBi Support Multiple SSID |
|
| RF, WDM, optical power:+2~-15dBm Optical reflection loss:≥45dB Optical receiving wavelength:1550±10nm CATV Interface RF frequency range:47~1000MHz, RF output impedance: 75Q RF output level:78dBuV AGC range:-13~+1dBm MER:≥32dBG-15dBm |
|
| 9 LED, For Status of PWR、LOS、PON、LAN1、LAN2、2.4G、5.8G LED Worn、Normal[CATV] |
|
| Push-Button 2 For Function of Factory Reset and WPS | |
| Operating Condition | Temperature:0℃~+50℃ Humidity:10%～90%(non-condensing) |
| Storing Condition | Temperature:-30℃~+60℃ Humidity:10%~90%(non-condensing) |
| Power Supply DC 12V/1A | |
| Power Consumption ≤6W | |
| Dimension 285mm×131mm×45mm(L×WxH) | |
| Net Weight 0.35Kg | |
PANEL LIGHTS INTRODUCTION
| Pilot Lamp | Status | Description | ||||
| PWR | On | The device is powered up | ||||
| Off | The device is powered down. | |||||
| LOS | Blink | The device doses not receive optical signals or with low signals. | ||||
| Off | The device has received optical signal | |||||
| PON | On | The device has registered to the PON system. | ||||
| Blink | The device is registering the PON system. | |||||
| Off | The device registration is incorrect. | |||||
| LAN1~LAN2 | On | Port [LANx] is connected properly (LINK). | ||||
| Blink | Port (LANx) is sending or/and receiving data (ACT). | |||||
| Off | Port (LANx) connection exception or not connected. | |||||
| 2.4G | On | 2.4G WIFl interface up | ||||
| Blink | 2.4G WIFl is sending or/and receiving data [ACT]. | |||||
| Off | 2.4G WIFl interface down | |||||
| 5.8G | On | 5G WIFl interface up | ||||
| Blink | 5G WIFl is sending or/and receiving data (ACT). | |||||
| Off | 5G WIFI interface down | |||||
| Worn[CATV] | On | Input optical power is higher than 3dbm or lower than-15dbm | ||||
| Off | Input optical power is between -15dbm and 3dbm | |||||
| Normal[CATV] | Blink | Input optical power is between -15dbm and 3dbm | ||||
| Off | Input optical power is higher than 3dbm or lower than-15dbm | |||||
FUNCTIONAL FEATURE
● Support EPON/GPON mode and switch mode automatically
● Support Route mode for PPPoE/IPoE/Static IP and Bridge mode
● Support IPv4 and IPv6 Dual mode
● Support 2.4G&5.8G WIFI and Multiple SSID
● Support CATV interface for Video Service and remote control by Major OLT
● Support Port Mapping and Loop-Detect
● Support Firewall function and ACL function
● Support IGMP Snooping/Proxy multicast feature
● Support TR069 remote configuration and maintenance
● Specialized design for system breakdown prevention to maintain stable system
APPLICATION
● Typical Solution ：FTTH(Fiber To The Home)
● Typical Business ：INTERNET、IPTV 、WIFI
Products categories
Write your message here and send it to us