HARDWARE SPECIFICATION
| Technical item | Detalls |
| PON Interface | 1GPONSFF Receiving sensitivity:≤-27dBm Transmitting optical power. 0~+5dBm Transmission distance: 20KM |
| Wavelength | TX:1310nm,RX1490nm |
| Optical Interface | SC/UPC Connector |
| Chip Spec | RTL9601D,DDR232MB |
| Flash | SPI Nor Flash 16MB |
| LAN Interface LED |
1x 10/100/1000Mbps auto adaptive Ethemet interf RJ45 connedor 94 LED,For Status of PWR、 LOS、 PON、 LINK/A |
| Push-Button | 1 For Function of Factory Reset |
| Operating Condition | Temperature:0 C~+50°C Humidity:10%~90%(non-condensing) |
| Storing Condition | Temperature:-30°0~+60°℃ Humidity:10%~90% (non-o oondensing) |
| Power Supply | DC 12V/0.5A |
| Power Consumption | <3W |
| Dimension | 75mmx75mmx28mm(LxWxH) 0 |
| NetWeight | Q.12Kg |
PANEL LIGHTS INTRODUCTION
| Pilot Lamp | Status | Description |
| PWR | On | The device is powered up. |
| Off | The device is powered down. | |
| PON | Blink | The device has registered to the PON system. |
| Off | The device registration is incorrect. | |
| LOS | Blink | The device doses not receive optical signals or with low signals. |
| Off | The device has received optical signal. | |
| LINK/ACT | On | Port is connected properly (LINK). |
| Blink | Port is sending or/and receiving data (ACT). | |
| Off | Port connection exception or not connected. |
Typical Solution： FTTO(Office)、 FTTB(Building)、 FTTH(Home)
Typical Business： INTERNET、 IPTV etc
Products categories
Write your message here and send it to us